According to relevant laws and regulations, the purifying power of qualified lampblack purifier must be higher than 85%, but because the method of the device is different, the fluctuation of the concentration of lampblack in the air inlet and the matching of the general fan are larger than lampblack purifier, so the purifying power of lampblack purifier which can really reach 85% purifying power must be 95%. So, how can we know that the purification power is over 95%?

靜電式油煙凈化器主要用于賓館、飯店、酒家、餐廳以及學校、機關、工廠等場所的廚房油煙的凈化管理；食物油炸、烹任加工職業；油濺熱處理車間、油霧光滑車間、工件焊接車間以及烯油鍋爐排放等工業場合。

Electrostatic fume purifier is mainly used for cleaning and management of kitchen fumes in hotels, restaurants, restaurants, schools, institutions and factories; food frying and cooking as processing professions; oil splash heat treatment workshop, oil mist smoothing workshop, workpiece welding workshop and olefin boiler emissions and other industrial occasions.

山東風管加工小編告訴您作業原理（油煙處理技能）：

Shandong wind pipe processing Xiaobian tells you the operation principle (oil smoke treatment skills):

油煙由風機吸入靜電油煙凈化器，其間部分較大的油霧滴、油污顆粒在均流板上因為機械磕碰、阻留而被捕集。當氣流進入高壓靜電場時，在高壓電場的效果下，油煙氣體電離，油霧荷電，大部分得以降解炭化；少部分細小油粒在吸附電場的電場力及氣流效果下向電場的正負極板運動被搜集在極板上并在本身重力的效果下流到集油盤，經排油通道排出，余下的微米級油霧被電場降解成二氧化碳和水，

Oil fume is inhaled by a fan into an electrostatic oil fume purifier, in which part of the larger oil droplets and oil contaminated particles are trapped on the equalizer due to mechanical bumping and blocking. When the gas flow enters the high voltage electrostatic field, under the effect of high voltage electric field, the fume gas ionizes and the oil mist charges, most of them are degraded and carbonized; a small number of fine oil particles are collected on the plate and flow to the oil collector under the effect of the electric field force adsorbed by the electric field and the gas flow. The remaining micron scale oil mist is degraded by electric field into carbon dioxide and water through the oil drain channel.

山東風管加工廠家與您分享油煙凈化器要怎樣清洗？

How does the Shandong wind pipe manufacturer share with you how to clean the fume purifier?

1，翻開設備的檢修門后，抽出電場之前要先將電場剩余電荷進行放電，應先用螺絲刀泄放電場中殘留電荷。

1. After opening the repair door of the equipment, the residual charge of the electric field should be discharged before the electric field is withdrawn, and the residual charge in the electric field should be discharged by screwdriver first.

2，清洗電場的一起，有必要嚴厲按時對機箱內部油污進行清洗，根絕繁殖火災危險。

2. When cleaning the electric field, it is necessary to clean the oil contamination inside the chassis strictly and on time to eradicate the danger of reproductive fire.

3，保證電源現已斷開的情況下，擰下固定用的螺栓，翻開保護門，再用手抽拉電場兩邊，在電場行將抽出時，末端用手扶住，防止俄然掉落，使電場受損。

3. To ensure that the power supply is disconnected, unscrew the bolt for fixing, open the protective door, and then pull both sides of the electric field by hand. When the electric field is about to be pulled out, the end is held by hand to prevent sudden drop and damage the electric field.

4，要把絕緣子拆下，一起分隔陰極針和陽極圓筒便利進一步清洗。

4, remove the insulator and separate the cathode pin and the anode cylinder together to facilitate further cleaning.

5，用一個不銹鋼或塑料清洗槽容器，外形大于電場外形尺寸就可。防止清洗時弄臟地板，故將油煙凈化器包裹起來，然后在容器中拆掉包裹袋。

5, use a stainless steel or plastic cleaning tank container, the shape is larger than the electric field size. To prevent the floor from being dirty during cleaning, wrap the soot purifier and remove the package bag in the container.

以上就是油煙凈化器的工作原理以及怎么樣清洗，希望以上內容對您有所幫助，更多相關內容請繼續關注：http://www.jzfckj.net/，感謝您的支持，濟南排煙罩將竭誠為您服務！

Above is the working principle of the lampblack purifier and how to clean it. I hope that the above content will be helpful to you. More related content please continue to pay attention to: http://www.jzfckj.net/. Thank you for your support, Jinan smoke hood will serve you wholeheartedly!